AWWA COMMENT PERIOD ON THE REAFFIRMATION WITHOUT REVISION OF AWWA C225, Fused Polyolefin Coatings for Steel Water Pipe

AWWA COMMENT PERIOD ON THE REAFFIRMATION WITHOUT REVISION OF AWWA C225, Fused Polyolefin Coatings for Steel Water Pipe

AWWA solicits public comments on all proposed new AWWA Standards, and on all proposed revisions, reaffirmations, or withdrawals of existing AWWA Standards. The referenced standards project is being considered for approval and the publication of this notice begins the 45-day public comment period for AWWA and ANSI. An electronic public review copy of the proposed standard can be obtained for review during the comment period by emailing ETS Support (ETSsupport@awwa.org). Comments must be submitted in writing to the AWWA contact listed below no later than the last day of the comment period specified herein. Such comments shall be specific to the section(s) of the standard under review and include sufficient detail, so as to enable the reader to understand the commenter’s position, concerns and suggested alternative language, if appropriate.

AWWA Comment Period closes on January 20, 2025.

Send comments to:
Liz Ralph, LRalph@awwa.org
303.347.6177 phone

The review copy will be edited for publication and may also be revised as appropriate based on any comments received during the public comment period. Therefore, this copy is not suitable for continued utilization and is intended only for comment purposes.

Final publication of the standard may take several months. When it is available, a notice will be published in the official notice section of Journal – American Water Works Association. The standard becomes an effective AWWA standard on the first day of the month following such publication in Journal – American Water Works Association.

SCOPE
This standard describes the materials and application of fused polyolefin coating systems for buried service. This system is applied in pipe coating plants, both portable and fixed, using coating techniques and equipment as recommended by the manufacturer. Typically, these prefabricated, polyolefin coatings are applied as a three-layer system consisting of (1) a liquid adhesive layer, (2) a corrosion-protection inner layer, and (3) a mechanical-protection outer layer.

MAJOR REVISIONS
There were no major revisions because this is a reaffirmation without revisions.