Standard Notices

AWWA COMMENT PERIOD ON AWWA B103 (formerly B1XX), Manganese Oxide Filter Media

July 9, 2025

image

AWWA Articles

AWWA COMMENT PERIOD ON AWWA B103 (formerly B1XX), Manganese Oxide Filter Media

AWWA COMMENT PERIOD ON AWWA B103 (formerly B1XX), Manganese Oxide Filter Media
July 11, 2025

AWWA solicits public comments on all proposed new AWWA Standards, and on all proposed revisions, reaffirmations, or withdrawals of existing AWWA Standards. The referenced standards project is being considered for approval and the publication of this notice begins the 45-day public comment period for AWWA and ANSI. An electronic public review copy of the proposed standard can be obtained for review during the comment period by emailing ETS Support (ETSsupport@awwa.org). Comments must be submitted in writing to the AWWA contact listed below no later than the last day of the comment period specified herein. Such comments shall be specific to the section(s) of the standard under review and include sufficient detail, so as to enable the reader to understand the commenter’s position, concerns and suggested alternative language, if appropriate.

AWWA Comment Period closes on August 25, 2025.

Send comments to:
Liz Ralph, LRalph@awwa.org
303.347.6177 phone

The review copy will be edited for publication and may also be revised as appropriate based on any comments received during the public comment period. Therefore, this copy is not suitable for continued utilization and is intended only for comment purposes.

Final publication of the standard may take several months. When it is available, a notice will be published in the official notice section of Journal – American Water Works Association. The standard becomes an effective AWWA standard on the first day of the month following such publication in Journal – American Water Works Association.

SCOPE
This standard describes mined and manufactured manganese oxide filter media as used in pressure and gravity filters to remove iron, manganese, radium, arsenic, and hydrogen sulfide in potable water treatment applications. It discusses handling, preparation, placement, sampling, and testing requirements specific to manganese oxide filter media as well as the reporting responsibilities of the manganese oxide filter media manufacturer.

Users of this standard should refer to ANSI/AWWA B100 for basic requirements of placing filter media, preparing filters for service, replenishing media in existing filter beds, sampling and testing media, and packaging and shipping media.

MAJOR REVISIONS
This is the first edition of this standard.

Advertisement