AWWA COMMENT PERIOD ON C205a – Addendum to C205-18

AWWA COMMENT PERIOD ON C205a – Addendum to C205-18, Cement-Mortar Protective Lining and Coating for Steel Water Pipe – 4 In. (100mm) and Larger – Shop Applied
Sept. 30, 2022

AWWA solicits public comments on all proposed new AWWA Standards, Addenda and on all proposed revisions, reaffirmations, or withdrawals of existing AWWA Standards. The referenced addendum project is being considered for approval and the publication of this notice begins the 30-day public comment period for AWWA and ANSI. An electronic public review copy of the proposed standard can be obtained for review during the comment period by emailing ETS Support. Comments must be submitted in writing to the AWWA contact listed below no later than the last day of the comment period specified herein. Such comments shall be specific to the section(s) of the standard under review and include sufficient detail so as to enable the reader to understand the commenter’s position, concerns and suggested alternative language, if appropriate.

AWWA Comment Period closes on October 30, 2022.

Send comments to:
Liz Ralph
303.347.6177 phone

The review copy will be edited for publication and may also be revised as appropriate based on any comments received during the public comment period. Therefore, this copy is not suitable for continued utilization and is intended only for comment purposes.

Final publication of the addendum may take several months. When it is available, a notice will be published in the official notice section of Journal – American Water Works Association. The addendum becomes an effective on the first day of the month following such publication in Journal – American Water Works Association. 

SCOPE
The addendum will include a revision to the requirements in sections of C205-18 to include ASTM C595 type IL cement as an additional allowable material for CML and CMC.