AWWA COMMENT PERIOD ON AWWA C232 (formerly C2VE) – Viscoelastic Coatings for Steel Water Pipe and Fittings

AWWA COMMENT PERIOD ON AWWA C232 (formerly C2VE) – Viscoelastic Coatings for Steel Water Pipe and Fittings
August 5, 2022

AWWA solicits public comments on all proposed new AWWA Standards, and on all proposed revisions, reaffirmations, or withdrawals of existing AWWA Standards. The referenced standards project is being considered for approval and the publication of this notice begins the 45-day public comment period for AWWA and ANSI. An electronic public review copy of the proposed standard can be obtained for review during the comment period by emailing ETS Support. Comments must be submitted in writing to the AWWA contact listed below no later than the last day of the comment period specified herein. Such comments shall be specific to the section(s) of the standard under review and include sufficient detail so as to enable the reader to understand the commenter’s position, concerns and suggested alternative language, if appropriate.

AWWA Comment Period closes on September 19, 2022.

Send comments to:
Liz Ralph
303.347.6177 phone

The review copy will be edited for publication and may also be revised as appropriate based on any comments received during the public comment period. Therefore, this copy is not suitable for continued utilization and is intended only for comment purposes.

Final publication of the standard may take several months. When it is available, a notice will be published in the official notice section of Journal – American Water Works Association. The standard becomes an effective AWWA standard on the first day of the month following such publication in Journal – American Water Works Association. 

SCOPE
This standard describes the materials and application of viscoelastic coating systems to the exterior of steel water pipe and fittings to be used for underground and under-water service.

MAJOR REVISIONS
This is a first edition.