AWWA Comment Period on ANSI/AWWA E102 – Submersible Vertical Turbine Pumps

AWWA Comment Period on ANSI/AWWA E102 – Submersible Vertical Turbine Pumps
July 21, 2023

AWWA solicits public comments on all proposed new AWWA Standards, and on all proposed revisions, reaffirmations, or withdrawals of existing AWWA Standards. The referenced standards project is being considered for approval and the publication of this notice begins the 45-day public comment period for AWWA and ANSI. An electronic public review copy of the proposed standard can be obtained for review during the comment period by emailing ETS Support. Comments must be submitted in writing to the AWWA contact listed below no later than the last day of the comment period specified herein. Such comments shall be specific to the section(s) of the standard under review and include sufficient detail so as to enable the reader to understand the commenter’s position, concerns and suggested alternative language, if appropriate.

AWWA Comment Period closes on Sept. 4, 2023.

Send comments to:
Jason Hrdlicka
303.347.6285 phone

The review copy will be edited for publication and may also be revised as appropriate based on any comments received during the public comment period. Therefore, this copy is not suitable for continued utilization and is intended only for comment purposes.

Final publication of the standard may take several months. When it is available, a notice will be published in the official notice section of Journal – American Water Works Association. The standard becomes an effective AWWA standard on the first day of the month following such publication in Journal – American Water Works Association. 

SCOPE
This standard provides minimum requirements for submersible vertical turbine pumps utilizing a discharge column pipe assembly for installation in wells, water treatment plants, water transmission systems, and water distribution systems.

MAJOR REVISIONS 
1. Clarifications to several definitions in Sec. 3.
2. Revision to the lead requirement in Sec. 4.1 to match regulatory requirements.
3. Addition of metric units and revisions to weights listed in Table 2 of Sec. 4.7.
4. Revisions to performance testing requirements in Secs. 5.2 and 5.3.
5. Removal of Secs. 5.6 through 5.11 to not conflict with ANSI/HI 14.6.